TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM, Diagnostic DTC:P17A0

DTC Code DTC Name
P17A0 Automatic Disconnecting Differential Motor Control Circuit Open

DESCRIPTION

This DTC is output when an open circuit in the A.D.D. shift motor drive circuit is detected.

DTC No. Detection Item DTC Detection Condition Trouble Area
P17A0 Automatic Disconnecting Differential Motor Control Circuit Open
  • Diagnosis Condition: While switching between H2 and H4 (A.D.D. shift motor operating) with the ignition switch turned to ON

  • Malfunction Status: Open circuit in the A.D.D. shift motor drive circuit

  • Malfunction Time: 0.03 seconds or more

  • Other: 1 trip detection logic


  • Wire harness and connector

  • 4 wheel drive control ECU

  • A.D.D. actuator (differential motor actuator assembly)

WIRING DIAGRAM

Refer to DTC P17A9.

Click here

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - DIFFERENTIAL MOTOR ACTUATOR ASSEMBLY)


    1. Disconnect the C40 4 wheel drive control ECU connector.

    2. Disconnect the C7 A.D.D. actuator (differential motor actuator assembly) connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      C40-2 (DM1) - C7-1 (DM1) Always Below 1 Ω
      C40-6 (DM2) - C7-2 (DM2) Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    NG
    OK
  2. INSPECT DIFFERENTIAL MOTOR ACTUATOR ASSEMBLY (A.D.D. SHIFT MOTOR)


    1. B0068FJC05
      *a

      Component without harness connected

      (A.D.D. Actuator (Differential Motor Actuator Assembly))

      Disconnect the C7 A.D.D. actuator (differential motor actuator assembly) connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (DM1) - 2 (DM2) Always 1.5 to 10 Ω
      Result
      Proceed to
      OK
      NG

    OK
    NG