CLUTCH UNIT(for RC60, RC61) INSPECTION

Click here Click here

PROCEDURE

1. Click here

   INSPECT CLUTCH DISC ASSEMBLY

   
   
   1. 

      Using a vernier caliper, measure the rivet head depth.

      Minimum rivet head depth
      0.3 mm (0.0118 in.)

      If the depth is less than the minimum, replace the clutch disc assembly.

   2. 

      Using a dial indicator, check the disc runout.

      Maximum runout
      0.8 mm (0.0314 in.)

      Note:

      Be sure to measure on the correct side of the clutch disc.

      If the runout is more than the maximum, replace the clutch disc assembly.

2. Click here

   INSPECT CLUTCH COVER ASSEMBLY

   
   
   1. 

      *a	Width
      *b	Depth

      Using a vernier caliper, measure the depth and width of the worn areas of the diaphragm spring.

      Maximum width
      6.0 mm (0.236 in.)

      Maximum depth
      0.35 mm (0.0137 in.)

      If the depth or width is more than the maximum, replace the clutch cover assembly.

3. Click here

   INSPECT FLYWHEEL SUB-ASSEMBLY

   
   
   1. 

      Using a dial indicator, measure the flywheel runout.

      Maximum runout
      0.1 mm (0.00393 in.)

      If the runout is more than the maximum, replace the flywheel sub-assembly.

4. Click here

   INSPECT CLUTCH RELEASE BEARING ASSEMBLY

   
   
   1. 

      Turn the bearing by hand while applying force in the axial direction and check that the bearing rotates smoothly.

      If the bearing sticks or a considerable amount of resistance is felt, replace the release bearing.

      Tip:

      The bearing is permanently lubricated and requires no cleaning or lubrication.

5. Click here

   INSPECT INPUT SHAFT FRONT BEARING

   
   
   1. 

      Turn the bearing by hand while applying rotational force and check that the bearing rotates smoothly.

      If the bearing sticks or a considerable amount of resistance is felt, replace the input shaft front bearing.

      Tip:

      The bearing is permanently lubricated and requires no cleaning or lubrication.

6. Click here

   REPLACE INPUT SHAFT FRONT BEARING

   
   

   1. Remove any 2 diametrically opposite bolts.

   2. 

      Using SST, remove the input shaft front bearing.

      09303-35011

   3. 

      Using SST and a hammer, tap in a new input shaft front bearing.

      09304-12012

      Tip:

      After installing the bearing to the crankshaft, make sure that it rotates smoothly.

   4. Install the new 2 bolts.

      178 N*m

      1815 kgf*cm

      131 ft.*lbf