AMPLIFIER ANTENNA

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the amplifier antenna removal/installation are shown below.

Table 1. Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system	Click here
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	Pre-collision system	Click here

CAUTION:

w/ Airbag System:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

PROCEDURE

Click here
PRECAUTION

Note:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Note:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
Click here
REMOVE ROOF HEADLINING ASSEMBLY
1. for Single Cab:
  
  Click here
2. for Smart Cab:
  
  Click here
3. for Double Cab:
  
  Click here
Click here
REMOVE ROOF ANTENNA POLE SUB-ASSEMBLY

Click here
Click here
REMOVE NO. 1 AMPLIFIER ANTENNA ASSEMBLY
1. Remove in this Direction
  
  w/o Telematics System
  1. Disconnect the connector and detach the clamp.
  2. Remove the nut.
2. Remove in this Direction
  
  w/ Telematics System
  1. Disconnect the connectors and detach the clamp.
  2. Remove the nut.
3. Detach the claws and remove the No. 1 amplifier antenna assembly.

AMPLIFIER ANTENNA REMOVAL