REAR DOOR SPEAKER(for Smart Cab) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR SPEAKER ASSEMBLY


    1. Install a nose piece to an air riveter or hand riveter. Then insert the mandrel part of a new φ4 mm waterproof rivet into the nose piece.

    2. B0026KN

      Using an air riveter or hand riveter, install the rear speaker assembly with 3 new rivets.

      Note


      • B0026OXC14
        *1 Mandrel
        *2 Riveter
        *a INCORRECT
        *b CORRECT

        Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

      • B002866C15
        *1 Riveter
        *a INCORRECT
        *b CORRECT

        Confirm that the rivets are seated properly against the speaker.

      • Do not tilt the riveter when installing the rivet to the speaker.

      • Do not leave any space between the rivet head and speaker.

      • B0024LEC14
        *1 Riveter
        *a INCORRECT
        *b CORRECT

        Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.

    3. Connect the connector.

  2. INSTALL REAR DOOR FRAME GARNISH LH

    Click here

  3. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  4. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH

    Click here

  5. INSTALL OUTER LAP BELT ANCHOR COVER

    Click here

  6. INSTALL SEAT BELT ANCHOR COVER CAP

    Click here

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.