REAR DOOR SPEAKER(for Smart Cab) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear door speaker removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point Pre-collision system

Click here

CAUTION:

w/ Airbag System:

B0027VM

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE SEAT BELT ANCHOR COVER CAP

    Click here

  4. REMOVE OUTER LAP BELT ANCHOR COVER

    Click here

  5. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH

    Click here

  6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  7. REMOVE REAR DOOR FRAME GARNISH LH

    Click here

  8. REMOVE REAR SPEAKER ASSEMBLY


    1. B0025W0N01

      Disconnect the connector.

    2. Put a 5 mm (0.197 in.) drill bit into a drill.

    3. Wind tape around the drill bit approximately 4 mm (0.157 in.) from the tip of the drill as shown in the illustration.

      Note

      Tape the drill bit to prevent the drill bit from going too deep.

      Standard
      Area Specified Condition
      A 4 mm (0.157 in.)

    4. Lightly press the drill against the rivets, drill off the flanges of the 3 rivets and remove the rear speaker assembly.

      CAUTION:

      Be careful of the drilled rivet as it may become hot.

      Note


      • Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.

      • Do not pry the rivet with the drill because this may cause damage to the installation holes of the rivet or the drill bit.

    5. Continue drilling and push out the remaining rivet fragments.

    6. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.