FRONT DOOR SPEAKER INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY


    1. Install a nose piece to an air riveter or hand riveter. Then insert the mandrel part of a new φ4 mm waterproof rivet into the nose piece.

    2. B0024FB

      Using an air riveter or hand riveter, install the front No. 1 speaker assembly with 3 new rivets.

      Note


      • B0026OXC07
        *a INCORRECT
        *b CORRECT
        *1 Mandrel
        *2 Riveter

        Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

      • B002866C18
        *a INCORRECT
        *b CORRECT
        *1 Riveter

        Confirm that the rivets are seated properly against the speaker.

      • Do not tilt the riveter when installing the rivet to the speaker.

      • Do not leave any space between the rivet head and speaker.

      • B0024LEC17
        *a INCORRECT
        *b CORRECT
        *1 Riveter

        Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.

    3. Connect the connector.

  2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  3. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  4. INSTALL FRONT ARMREST ASSEMBLY LH

    Click here

  5. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (w/ Power Window)

    Click here

  6. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click here

  7. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY


    1. B0024H9

      Attach the claws to install the front No. 2 speaker assembly.

  8. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.