FRONT DOOR SPEAKER REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

B00291E

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  4. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY


    1. B0024H9

      Detach the claws and front No. 2 speaker assembly.

  5. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click here

  6. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (w/ Power Window)

    Click here

  7. REMOVE FRONT ARMREST ASSEMBLY LH

    Click here

  8. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  9. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  10. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


    1. B00284VN01

      Disconnect the connector.

    2. Put a 5 mm (0.197 in.) drill bit into a drill.

    3. Wind tape around the drill bit approximately 4 mm (0.157 in.) from the tip of the drill as shown in the illustration.

      Note

      Tape the drill bit to prevent the drill bit from going too deep.

      Standard
      Area Specified Condition
      A 4 mm (0.157 in.)

    4. Lightly press the drill against the rivets, drill off the flanges of the 3 rivets and remove the front No. 1 speaker assembly.

      CAUTION:

      Be careful of the drilled rivet as it may become hot.

      Note


      • Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.

      • Do not pry the rivet with the drill because this may cause damage to the installation holes of the rivet or the drill bit.

    5. Continue drilling and push out the remaining rivet fragments.

    6. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.