STEERING WHEEL INSTALLATION

PROCEDURE


  1. INSTALL LOWER STEERING WHEEL BOSS COVER


    1. Attach the 2 guide pins and 4 claws to install the lower steering wheel boss cover.

  2. ADJUST SPIRAL CABLE

    Click here

  3. INSTALL STEERING WHEEL ASSEMBLY


    1. Align the matchmarks on the steering wheel assembly and steering main shaft.

    2. Install the steering wheel set nut.

      Torque:
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

  4. INSTALL CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)

    Click here

  5. INSTALL NO. 1 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)


    1. Attach the 6 guide pins and 2 claws to install the No. 1 steering wheel ornament.

    2. Install the 2 screws.

  6. INSTALL STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)

    Click here

  7. INSTALL HORN BUTTON ASSEMBLY (w/o Airbag System)


    1. Connect the horn wire.

    2. B0025B2C01
      *a Upper Pin
      *b Lower Pin

      Press the horn button assembly with both hands to attach the upper pin to the spring.

    3. Press the horn button assembly with both hands to attach the lower pin to the spring.

      Note

      After installation, try to pull the horn button assembly and check that the horn button assembly is securely installed.

  8. INSTALL LOWER NO. 2 STEERING WHEEL COVER (w/o Airbag System)


    1. Attach the guide and claw to install the lower No. 2 steering wheel cover.

  9. INSTALL STEERING WHEEL PAD ASSEMBLY (w/ Airbag System)

    Click here

  10. INSPECT STEERING WHEEL CENTER POINT

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  12. INSPECT HORN BUTTON ASSEMBLY


    1. With the horn button assembly installed to the vehicle, perform a visual check. If any of the defects mentioned below are found, replace the horn button assembly with a new one:

      Cuts, minute cracks or marked discoloration on the horn button assembly top surface or in the grooved portion.

    2. Make sure that the horn sounds.

      Tech Tips

      If the horn does not sound, inspect the horn system.

      Click here

  13. CHECK SRS WARNING LIGHT

    for Type A: Click here

    for Type B: Click here