Click here

REAR BRAKE(for TMT Made 2WD) INSTALLATION

Click here
Click here Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

Click here

PROCEDURE


  1. Click here

    INSTALL REAR BRAKE DRUM SUB-ASSEMBLY


    1. Install a new brake drum gasket and rear brake drum sub-assembly.

  2. Click here

    ADJUST REAR DRUM BRAKE SHOE CLEARANCE


    1. Temporarily install 2 wheel nuts.

    2. B002937C01
      B0069FO Expand

      Using a screwdriver, remove the shoe adjusting hole plug, and turn the adjuster to expand the shoe until the drum locks.

    3. B0024MBC01
      *1 Rear Brake Automatic Adjust Lever
      B0069FO Contract

      Hold the rear brake automatic adjust lever away from the adjuster, and contract the brake shoe by turning the adjustment bolt using another screwdriver until the drum rotates smoothly.

      Standard
      11 notches

    4. Install the shoe adjusting hole plug.

    5. B0028XO

      Measure the brake drum inner diameter and the diameter of the brake shoes. Check that the difference between the diameters is equal to the specified shoe clearance.

      Standard Shoe Clearance
      0.5 mm (0.0197 in.)
  3. Click here

    BLEED BRAKE LINE (w/ VSC)

    Click here

  4. Click here

    BLEED BRAKE LINE (w/o VSC)

    Click here

  5. Click here

    BLEED CLUTCH LINE (for Manual Transmission)

    Click here

  6. Click here

    INSTALL REAR WHEEL

    Click here

  7. Click here

    CHECK PARKING BRAKE LEVER TRAVEL

    Click here

  8. Click here

    ADJUST PARKING BRAKE LEVER TRAVEL

    Click here