Click here

REAR BRAKE(for TSAM Made 2WD) REMOVAL

Click here
Click here Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

Click here

PROCEDURE


  1. Click here

    CHECK BRAKE SHOE LINING THICKNESS


    1. A01SCAR

      Remove the shoe inspection hole plug, and check the brake shoe lining thickness through the hole.

      Minimum thickness
      1.0 mm (0.0394 in.)

      If the thickness is less than the minimum, replace the brake shoe.

  2. Click here

    REMOVE REAR WHEEL

    Click here

  3. Click here

    DRAIN BRAKE FLUID

    Note:

    Wash off brake fluid immediately if it comes in contact with any painted surface.

  4. Click here

    REMOVE REAR BRAKE DRUM SUB-ASSEMBLY


    1. Release the parking brake lever, and remove the rear brake drum sub-assembly and brake drum gasket.

      Tip:

      If the rear brake drum sub-assembly cannot be removed easily, perform the following procedures.

    2. A01SCUBC01
      *1 Automatic Adjust Lever
      *2 Brake Shoe Adjuster

      Remove the shoe adjusting hole plug and insert a screwdriver into the hole on the backing plate, and hold the automatic adjust lever away from the adjuster.

    3. Using another screwdriver, compress the brake shoe adjuster by turning the adjusting wheel.