FRONT BRAKE(for 15 inch Front Disc Brake 2WD) DISASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE CYLINDER BOOT


    1. A01LF8IC01
      *a Protective Tape

      Using a screwdriver, remove the cylinder boot from the disc brake cylinder assembly LH.

      Tech Tips

      Tape the screwdriver tip before use.

      Note

      Be careful not to damage the front disc brake piston and disc brake cylinder assembly LH.

  2. REMOVE FRONT DISC BRAKE PISTON


    1. A01LCOMC01
      *a Cloth

      Place a piece of cloth between the front disc brake piston and disc brake cylinder assembly LH.

    2. Apply compressed air to remove the front disc brake piston from the disc brake cylinder assembly LH.

      CAUTION:

      Do not place your fingers in front of the piston when using compressed air.

      Note

      Be careful not to spatter the brake fluid.

  3. REMOVE PISTON SEAL


    1. A01L8V7C01
      *a Protective Tape

      Using a screwdriver, remove the piston seal from the disc brake cylinder assembly LH.

      Tech Tips

      Tape the screwdriver tip before use.

      Note

      Be careful not to damage the inner cylinder and cylinder groove.

  4. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP

  5. REMOVE FRONT DISC BRAKE BLEEDER PLUG


    1. Remove the front disc brake bleeder plug from the disc brake cylinder assembly LH.