REAR BRAKE(for TMT Made 4WD and Pre-Runner) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. CHECK BRAKE SHOE LINING THICKNESS

    A01SAQP

    1. Remove the shoe inspection hole plug, and check the shoe lining thickness through the hole.

      Minimum thickness
      1.0 mm (0.0394 in.)

      If the thickness is less than the minimum, replace the brake shoe.

  2. REMOVE REAR WHEEL

    Click here

  3. DRAIN BRAKE FLUID

    Note

    Wash off brake fluid immediately if it comes in contact with any painted surface.

  4. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY


    1. Release the parking brake lever, and remove the rear brake drum sub-assembly and brake drum gasket.

      Tech Tips

      If the rear brake drum sub-assembly cannot be removed easily, perform the following procedures.

    2. A01LEY4C01
      *1 Automatic Adjust Lever
      *2 Brake Shoe Adjuster

      Remove the shoe adjusting hole plug and insert a screwdriver into the hole on the backing plate, and hold the automatic adjust lever away from the adjuster.

    3. Using another screwdriver, compress the brake shoe adjuster by turning the adjusting wheel.