BRAKE PEDAL REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

  4. REMOVE BRAKE PEDAL RETURN SPRING


    1. B00276M

      Remove the brake pedal return spring from the brake pedal support sub-assembly and push rod pin.

  5. REMOVE PUSH ROD PIN


    1. B0025VE

      Remove the clip from the push rod pin.

    2. Remove the push rod pin from the brake master cylinder push rod clevis.

  6. REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY


    1. B0025Y8

      Disconnect the connector from the stop light switch assembly.

    2. Detach the 2 clamps from the brake pedal support sub-assembly.

    3. B0028AC

      Remove the brake pedal support reinforcement set bolt.

    4. B0028US

      Remove the 4 nuts and brake pedal support sub-assembly.

    5. Remove the nut from the brake pedal support sub-assembly.

  7. REMOVE STOP LIGHT SWITCH ASSEMBLY

    Click here