TRANSMISSION WIRE INSPECTION

PROCEDURE

1. *a Component without harness connected (Transmission Wire)
   Click here

   INSPECT TRANSMISSION WIRE

   
   

   1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition 3 (OT+) - 4 (OT-) Always 79 Ω to 156 kΩ 5 (OT2+) - 6 (OT2-) Always 25 Ω to 156 kΩ 3 (OT+) - Body ground Always 10 kΩ or higher 5 (OT2+) - Body ground Always 10 kΩ or higher 4 (OT-) - Body ground Always 10 kΩ or higher 6 (OT2-) - Body ground Always 10 kΩ or higher

      Tip:

      If the resistance is out of the specified range at any of the ATF temperatures shown in the table below, the driveability of the vehicle may decrease.

      Standard Resistance
      ATF Temperature Specified Condition 10°C (50°F) 5 to 8 kΩ 25°C (77°F) 2.5 to 4.5 kΩ 110°C (230°F) 0.22 to 0.28 kΩ

      If the result is not as specified, replace the transmission wire.