CRUISE CONTROL MAIN SWITCH

CAUTION / NOTICE / HINT

Tip:

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the cruise control main switch removal/installation are shown below.

Table 1. Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system	Click here
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	Pre-collision system	Click here

Click here

PROCEDURE

Click here
PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

for Type A:

Click here

for Type B:

Click here

for Type C:

Click here

Note:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here
Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- If the airbag deploys for any reason, it may cause a serious accident.
Note:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
Click here
REMOVE HORN BUTTON ASSEMBLY

Click here
Click here
REMOVE CRUISE CONTROL MAIN SWITCH
1. Remove the 2 screws.
2. Disconnect the connector and remove the cruise control main switch.
3. Disconnect the connector and remove the cruise control switch wire from the cruise control main switch.

CRUISE CONTROL MAIN SWITCH REMOVAL