LANE DEPARTURE ALERT SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • Use these procedures to troubleshoot the lane departure alert system.

  • *: Use the GTS.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. INSPECT BATTERY


    1. Measure the battery voltage with the ignition switch off.

      Standard voltage
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

      Result
      Proceed to
      NEXT

    NEXT

  3. CHECK CAN COMMUNICATION SYSTEM*


    1. Using the GTS, check if the CAN communication system is functioning normally.

      Tech Tips

      Refer to CAN Bus Check in CAN Communication System.

      for LHD: Click here

      for RHD: Click here

      OK
      CAN communication system is functioning normally.
      Result
      Proceed to
      OK
      NG

    NG

    GO TO CAN COMMUNICATION SYSTEM for LHD: Click here
    GO TO CAN COMMUNICATION SYSTEM for RHD: Click here

    OK

  4. CHECK FOR DTCs* (LANE DEPARTURE ALERT SYSTEM)

    Tech Tips

    Refer to DTC Check / Clear.

    Click here


    1. Check for DTCs and note any codes that are output.


      Chassis > LKA/LDA > Trouble Codes

    2. Clear the DTCs.


      Chassis > LKA/LDA > Clear DTCs

    3. Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.


      Chassis > LKA/LDA > Trouble Codes
      Result
      Result Proceed to
      DTCs are not output A
      DTCs are output B

    B

    GO TO DTC CHART Click here

    A

  5. PROBLEM SYMPTOMS TABLE

    Tech Tips

    Refer to Problem Symptoms Table.

    Click here

    Result
    Result Proceed to
    Fault is not listed in Problem Symptoms Table A
    Fault is listed in Problem Symptoms Table B

    B

    GO TO STEP 8 Click here

    A

  6. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Terminals of ECU

      Click here

    2. Data List / Active Test

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  7. ADJUST, REPAIR OR REPLACE

    Note

    When the forward recognition camera is replaced with a new one, Forward Recognition Camera Axis Adjustment must be performed.

    Click here

    Result
    Proceed to
    NEXT

    NEXT

  8. CONFIRMATION TEST

    Result
    Proceed to
    NEXT

    NEXT

    END