STARTER(for BOSCH Made) INSTALLATION

PROCEDURE

1. Click here

   INSTALL STARTER ASSEMBLY

   
   

   1. for Manual Transmission:

      
      

      1. Temporarily install the starter assembly with the bolt.

      2. Temporarily install the clutch flexible bracket with the bolt.

      3. Tighten the 2 bolts.

         37 N*m

         377 kgf*cm

         27 ft.*lbf

   2. for Automatic Transmission:

      
      

      1. Install the starter assembly with the 2 bolts.

         37 N*m

         377 kgf*cm

         27 ft.*lbf

   3. Connect the starter wire with the nut.

      9.8 N*m

      100 kgf*cm

      87 in.*lbf

   4. Connect the terminal cap.

   5. Connect the starter connector.

2. Click here

   CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

   Click here

3. Click here

   INSTALL FRONT FENDER SEAL LH

   
   

   1. for 2WD:

      Install the front fender seal LH with 5 new clips.

   2. for 4WD and Pre-Runner:

      Install the front fender seal LH with 6 new clips.

4. Click here

   CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here