STARTER(for BOSCH Made) REMOVAL

PROCEDURE

1. PRECAUTION

   Note

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

   Click here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

3. REMOVE FRONT FENDER SEAL LH

   
   

   1. for 2WD:

      Remove the 5 clips and front fender seal LH.

   2. for 4WD and Pre-Runner:

      Remove the 6 clips and front fender seal LH.

4. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

   Click here

5. REMOVE STARTER ASSEMBLY

   
   

   1. 

      Disconnect the starter connector.

   2. Disconnect the terminal cap.

   3. Remove the nut and disconnect the starter wire.

   4. for Manual Transmission:

      
      

      1. 

         Remove the bolt and disconnect the clutch flexible hose bracket.

      2. Remove the bolt and starter assembly.

   5. for Automatic Transmission:

      
      

      1. 

         Remove the 2 bolts and starter assembly.