STARTER(for 2.0 kW Type) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT FENDER SEAL LH


    1. Remove the 6 clips and front fender seal LH.

  4. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

    Click here

  5. REMOVE STARTER ASSEMBLY


    1. B0025P7

      Detach the wire harness clamp and remove the bolt to disconnect the wire harness.

    2. B00269U

      Disconnect the starter connector.

    3. Disconnect the terminal cap.

    4. Remove the nut and disconnect the starter wire.

    5. for Manual Transmission:


      1. B0027TT

        Remove the bolt and disconnect the clutch flexible hose bracket.

      2. Remove the bolt and starter assembly.

    6. for Automatic Transmission:


      1. B0027W3

        Remove the 2 bolts and starter assembly.