GLOW PLUG INSTALLATION

PROCEDURE

1. Click here

   INSTALL GLOW PLUG ASSEMBLY

   
   

   1. Using a 12 mm deep socket wrench, install the 4 glow plug assemblies.

      13 N*m

      133 kgf*cm

      10 ft.*lbf

2. Click here

   INSTALL NO. 1 GLOW PLUG CONNECTOR

   
   

   1. Install the No. 1 glow plug resistor insulator.

   2. Install the No. 1 glow plug connector by uniformly tightening the 4 nuts.

      1.0 N*m

      10 kgf*cm

      9 in.*lbf

   3. Install the 4 screw grommets.

   4. Connect the engine wire and install the No. 2 glow plug resistor insulator and plate washer with the nut.

      5.0 N*m

      51 kgf*cm

      44 in.*lbf

3. Click here

   INSTALL INTAKE PIPE

   
   

   1. Temporarily install the intake pipe.

   2. 

      *a	Hose Clamp A
      *b	Hose Clamp B
      *c	Bolt

      Install the 2 bolts.

      18 N*m

      184 kgf*cm

      13 ft.*lbf

   3. Tighten the 2 hose clamps to secure the intake pipe.

      for hose clamp A
      4.0 N*m	41 kgf*cm	35 in.*lbf
      for hose clamp B
      6.0 N*m	61 kgf*cm	53 in.*lbf

4. Click here

   CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here