STARTER INSTALLATION

PROCEDURE

1. Click here

   INSTALL STARTER ASSEMBLY

   
   
   1. 

      Temporarily install the starter assembly and ground cable with the nut and 2 bolts.

   2. Tighten bolt A and nut B.

      68 N*m

      693 kgf*cm

      50 ft.*lbf

   3. Connect the starter wire with the nut.

      9.8 N*m

      100 kgf*cm

      87 in.*lbf

   4. Connect the starter connector.

   5. Install the starter terminal cap.

2. Click here

   INSTALL STARTER STAY

   
   

   1. Install the starter stay with the nut and 2 bolts.

      12.3 N*m

      125 kgf*cm

      9 ft.*lbf

3. Click here

   INSTALL FRONT FENDER SEAL LH

   
   

   1. Install the front fender seal LH with 6 new clips.

4. Click here

   CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here