STARTER(w/ Stop And Start System) COMPONENTS
ILLUSTRATION
| *1 | NO. 1 ENGINE UNDER COVER ASSEMBLY | *2 | NO. 2 ENGINE UNDER COVER |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | for 4WD | - | - |
| *1 | FRONT DIFFERENTIAL CARRIER ASSEMBLY | *2 | DIFFERENTIAL BREATHER TUBE BRACKET |
| *3 | DIFFERENTIAL MOUNT NUT | *4 | FRONT MOUNTING BOLT |
| *5 | FRONT NO. 3 DIFFERENTIAL SUPPORT | *6 | LOWER DIFFERENTIAL MOUNT STOPPER |
| *7 | UPPER DIFFERENTIAL MOUNT STOPPER | *8 | WIRE HARNESS |
| *a | For use with 17mm ball joint lock nut wrench | - | - |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | |
N*m (kgf*cm, ft.*lbf): Specified torque |
 |
Do not apply lubricants | - | - |
ILLUSTRATION
| *A | for Automatic Transmission | *B | for Manual Transmission |
| *C | w/ Urea SCR System | - | - |
| *1 | CLUTCH FLEXIBLE HOSE BRACKET | *2 | CLUTCH RELEASE CYLINDER ASSEMBLY |
| *3 | FRONT FENDER SEAL LH | *4 | NO. 2 UREA TANK FILLER PIPE SUPPORT |
| *5 | STARTER ASSEMBLY | *6 | CLIP |
| *7 | NO. 1 CLUTCH TUBE BRACKET | *8 | STARTER CONNECTOR |
| *9 | STARTER WIRE | *10 | GROUND CABLE |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |