Click here

STARTER(for BOSCH Made) REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the starter assembly removal/installation are shown below.

Table 1. Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedures not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

Click here
Memorize steering angle neutral point Pre-crash safety system

Click here
Click here

PROCEDURE


  1. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. Click here

    REMOVE FRONT FENDER SEAL LH


    1. Remove the 6 clips and front fender seal LH.

  4. Click here

    REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

  5. Click here

    REMOVE NO. 2 ENGINE UNDER COVER

  6. Click here

    DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

    Click here

  7. Click here

    REMOVE STARTER ASSEMBLY


    1. Remove the starter terminal cap.

    2. Disconnect the starter connector.

    3. B002476

      Remove the nut and disconnect the starter wire.

    4. B0024BL

      Remove the bolt and disconnect the clutch flexible hose bracket.

    5. Remove the bolt, starter assembly and disconnect the ground cable.