TRANSMISSION WIRE INSTALLATION

PROCEDURE

1. Click here

   INSTALL TRANSMISSION WIRE

   
   

   1. Coat 2 new O-rings with ATF, and install them to the 2 temperature sensors.

   2. Coat a new O-ring with ATF, and install it to the transmission wire.

   3. Install the transmission wire to the automatic transmission case sub-assembly with the bolt.

      5.4 N*m

      55 kgf*cm

      48 in.*lbf

   4. Connect the transmission wire connector.

      Tip:

      Push up the lever until the claw of the transmission wire connector makes a connection sound.

2. Click here

   INSTALL TRANSMISSION INSULATOR RH

   
   

   1. Install the transmission insulator RH to the automatic transmission assembly with the 6 bolts.

      14 N*m

      143 kgf*cm

      10 ft.*lbf

3. Click here

   CONNECT TRANSMISSION WIRE

   
   
   1. 

      *A	w/ Stop and Start System
      *1	Temperature Sensor Clamp
      *2	Temperature Sensor

      w/ Stop and Start System:

      Connect the electromagnetic oil pump connector.

   2. Connect the 7 solenoid valve connectors.

   3. Install the 2 temperature sensors and the 2 temperature sensor clamps to the transmission valve body assembly with the bolt.

      for Bolt A
      10 N*m	102 kgf*cm	7 ft.*lbf
      for Bolt B
      11 N*m	112 kgf*cm	8 ft.*lbf

4. Click here

   INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

   
   
   1. 

      Install the 4 transmission oil cleaner magnets to the automatic transmission oil pan sub-assembly as shown in the illustration.

   2. Install a new automatic transmission oil pan gasket to the automatic transmission oil pan sub-assembly.

   3. 

      *1	Sleeve
      *2	Automatic Transmission Case Sub-assembly
      *a	Correct
      *b	Incorrect
      *c	Protrusion

      Install the automatic transmission oil pan sub-assembly with automatic transmission oil pan gasket to the automatic transmission case sub-assembly with the 10 bolts.

      7.4 N*m

      75 kgf*cm

      65 in.*lbf

      Note:
      

      • Make sure that automatic transmission oil pan gasket seal surface and automatic transmission oil pan sub-assembly contact surface are free of oil and foreign matter.

      • Install the automatic transmission oil pan gasket so that there is no slack in the automatic transmission oil pan gasket, and the entire seal surface is level.

      • Make sure that the 8 protrusions are properly engaged to the automatic transmission oil pan sub-assembly.

      • When installing the automatic transmission oil pan sub-assembly, make sure that the automatic transmission oil pan gasket is not pinched between the sleeve and the seal surface of the automatic transmission case sub-assembly.

5. Click here

   ADD AUTOMATIC TRANSMISSION FLUID

   Click here

6. Click here

   ADJUST AUTOMATIC TRANSMISSION FLUID

   Click here