OIL PRESSURE SWITCH INSTALLATION

PROCEDURE


  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    1. B0024YAC01
      *a Adhesive

      Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      Note

      Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.

    2. Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly to the oil filter bracket.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine for at least 1 hour after the installation.

    3. Connect the engine oil pressure switch connector.

  2. ADD ENGINE OIL

    Click here

  3. INSPECT FOR OIL LEAK

    Click here

  4. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY (for 4WD and Pre-Runner)

    Click here

  5. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY (for 4WD and Pre-Runner)

    Click here