THERMOSTAT INSTALLATION

PROCEDURE


  1. INSTALL THERMOSTAT


    1. B00250WC06
      *1 Gasket
      *a Jiggle Valve
      *b CORRECT
      *c INCORRECT
      B0068HS Upward

      Install a new gasket to the thermostat.

      Note

      When installing the gasket to the thermostat, be careful not to deform the gasket. Make sure that the groove of the gasket is properly installed to the thermostat, as shown in the illustration.

    2. Insert the thermostat into the cylinder block with the jiggle valve facing straight upward.

      Tech Tips

      The jiggle valve may be set within 30° of either side of the prescribed position.

  2. INSTALL WATER INLET


    1. Install the water inlet with the 3 bolts.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

    2. Connect the wire harness with the bolt to the water inlet.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

  3. CONNECT NO. 2 RADIATOR HOSE


    1. Connect the No. 2 radiator hose to the water inlet.

  4. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  5. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

    Click here

  6. INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH AIR CLEANER HOSE

    Click here

  7. INSTALL PCV HOSE HEAT INSULATOR

    Click here

  8. ADD ENGINE COOLANT

    Click here

  9. INSPECT FOR COOLANT LEAK

    Click here