Click here

EXHAUST PIPE INSTALLATION

Click here
Click here

PROCEDURE


  1. Click here

    INSTALL FRONT EXHAUST PIPE ASSEMBLY


    1. A01SAWK

      Using a vernier caliper, measure the free length of the compression spring.

      Minimum length
      40 mm (1.57 in.)

      If the free length is less than the minimum, replace the compression spring.

    2. Using a wire brush, remove any foreign matter from the gasket installation surface.

    3. B006913C38
      *1 Gasket
      *a Wooden Block

      Using a plastic-faced hammer and wooden block, tap on a new gasket until its surface is flush with the exhaust manifold.

      Note:
      • Be sure to install the gasket so that it faces the correct direction.

      • Do not reuse the gasket.

      • Do not damage the gasket.

      • When connecting the front exhaust pipe assembly, do not push in the gasket with the front exhaust pipe assembly.

    4. Install the front exhaust pipe assembly to the No. 1 exhaust pipe support.

    5. Connect the front exhaust pipe assembly to the exhaust manifold with the 2 compression springs and 2 bolts. Alternately tighten the bolts in several passes.

      43 N*m 438 kgf*cm 32 ft.*lbf
  2. Click here

    INSTALL HEATED OXYGEN SENSOR

    Click here

  3. Click here

    INSTALL AIR FUEL RATIO SENSOR

    Click here

  4. Click here

    INSTALL TAIL EXHAUST PIPE ASSEMBLY


    1. Install the tail exhaust pipe assembly to the 3 No. 1 exhaust pipe supports and No. 2 exhaust pipe support.

    2. Install a new gasket and the tail exhaust pipe assembly to the front exhaust pipe assembly with the 2 bolts and 2 new nuts. Alternately tighten the bolts in several passes.

      43 N*m 438 kgf*cm 32 ft.*lbf
      Note:

      Do not reuse the gasket.

  5. Click here

    INSTALL FRONT FENDER SEAL RH

    Click here

  6. Click here

    INSPECT FOR EXHAUST GAS LEAK

    If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.

    Tip:

    If an exhaust gas leak has been repaired, perform an inspection following the repair.

    Click here