EXHAUST GAS TEMPERATURE SENSOR(w/ Urea SCR System) INSTALLATION

PROCEDURE


  1. INSTALL NO. 4 EXHAUST GAS TEMPERATURE SENSOR


    1. B0068F6C01
      *a Torque Wrench Fulcrum Length

      Using a 14 mm union nut wrench, install the No. 4 exhaust gas temperature sensor to the front exhaust pipe assembly.

      Torque:
      Specified tightening torque
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note

      If the No. 4 exhaust gas temperature sensor is dropped, replace it with a new one.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using a union nut wrench (fulcrum length of 25 mm (0.984 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 26 N*m (268 kgf*cm, 19 ft.*lbf)

    2. Attach the 2 clamps and connect the No. 4 exhaust gas temperature sensor to the sensor bracket.

    3. Connect the connector to the No. 4 exhaust gas temperature sensor.