EGR COOLER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the EGR cooler removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of diesel throttle body assembly Perform initialization -

Click here

Replacement of electric EGR control valve assembly Perform initialization -

Click here

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.

B0068EY

PROCEDURE


  1. DRAIN ENGINE COOLANT

    Click here

  2. REMOVE DIESEL THROTTLE BODY ASSEMBLY

    Click here

  3. REMOVE NO. 2 WATER BY-PASS PIPE

    Click here

  4. REMOVE GAS FILTER

    Click here

  5. REMOVE TURBO PRESSURE SENSOR

    Click here

  6. REMOVE NO. 2 HOSE TO HOSE TUBE

    Click here

  7. REMOVE NO. 2 ENGINE COVER BRACKET

    Click here

  8. DISCONNECT FUEL FILTER ASSEMBLY

    Click here

  9. DISCONNECT ENGINE WIRE

    Click here

  10. REMOVE EGR VALVE BRACKET

    Click here

  11. REMOVE NO. 2 EGR PIPE

    Click here

  12. DISCONNECT NO. 3 WATER BY-PASS PIPE SUB-ASSEMBLY

    CAUTION:

    To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


    1. A01L8Y4

      Disconnect the No. 4 fuel hose from the No. 3 water by-pass pipe sub-assembly.

    2. A01LCAK

      Slide the clamp and disconnect the No. 8 water by-pass hose from the No. 3 water by-pass pipe sub-assembly.

    3. Slide the clamp and disconnect the No. 9 water by-pass hose from the electric EGR control valve assembly.

    4. Remove the 2 bolts and No. 3 water by-pass pipe sub-assembly from the No. 1 EGR cooler.

  13. DISCONNECT NO. 4 WATER BY-PASS PIPE SUB-ASSEMBLY

    Click here

  14. REMOVE EGR PIPE WITH COOLER SUB-ASSEMBLY (w/ DPF)

    Click here

  15. REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY (w/o DPF)

    Click here

  16. REMOVE VACUUM CONTROL VALVE SET

    Click here

  17. REMOVE NO. 1 EGR COOLER AND NO. 2 EGR VALVE ASSEMBLY WITH ELECTRIC EGR CONTROL VALVE ASSEMBLY

    CAUTION:

    To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


    1. A01LA7Y

      Remove the 4 bolts and No. 1 EGR cooler and No. 2 EGR valve assembly with electric EGR control valve assembly from the intake manifold.

  18. REMOVE NO. 1 EGR COOLER


    1. A01LD5P

      Remove the 4 bolts and No. 1 EGR cooler from the No. 2 EGR valve assembly with electric EGR control valve assembly.

    2. Remove the gasket.