STARTER INSTALLATION

PROCEDURE

1. INSTALL FLYWHEEL HOUSING SIDE COVER

   
   

   1. Install the flywheel housing side cover to the cylinder block.

2. INSTALL STARTER ASSEMBLY

   
   

   1. Install the starter assembly with the 2 bolts.

      Torque:

      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

   2. Connect the wire harness bracket with the bolt.

      Torque:

      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

   3. Connect the starter wire with the nut.

      Torque:

      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

   4. Connect the terminal cap.

   5. Connect the starter wire to the cylinder block with the bolt.

      Torque:

      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

   6. Connect the starter connector.

3. INSTALL FRONT FENDER SEAL LH

   Click here

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here