OIL PRESSURE SWITCH INSTALLATION

PROCEDURE

1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

   
   

   1. Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      Note

      Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.

   2. Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly to the oil cooler cover sub-assembly.

      Torque:

      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine for at least 1 hour after the installation.

   3. Connect the connector to the engine oil pressure switch assembly.

2. ADD ENGINE OIL

   Click here

3. INSPECT FOR OIL LEAK

   Click here