FUEL INJECTOR ON-VEHICLE INSPECTION

PROCEDURE


  1. CHECK INJECTOR ASSEMBLY


    1. Start the engine and drive the vehicle until the engine coolant temperature reaches 60°C (140°F) or higher.

    2. Allow the engine to idle for 1 minute or more.

    3. Connect the GTS to the DLC3.

    4. Turn the GTS on.

    5. Enter the following menus: Powertrain / Engine / Data List / Injection Volume and Injector Feedback Val. #1 to #4.


      Powertrain > Engine > Data List
      Tester Display
      Injection Feedback Val #1
      Injection Feedback Val #2
      Injection Feedback Val #3
      Injection Feedback Val #4

    6. Read the values when the engine is idling.

    7. Check that the "Injector Feedback Val. #1 to #4" values are within the specification.

      Standard
      Tester Display Engine Condition Specified Condition
      Injection Volume Idling

      3 to 10 mm3/st

      Injector Feedback Val. #1

      Injector Feedback Val. #2

      Injector Feedback Val. #3

      Injector Feedback Val. #4

      		 Idling

      -3.0 to 3.0 mm3/st

      If the result is not as specified, replace the fuel injector assembly.

  2. CHECK INJECTOR COMPENSATION CODE

    Tech Tips

    If the injector compensation code is not correctly registered, it may cause malfunctions.


    1. Read the injector compensation code.

      Click here

    2. Check that the compensation code of the installed injector assembly is the same as the code registered in the ECM. If the code is not the same, register the injector compensation code on the injector assembly.

      Click here