FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL FRONT CRANKSHAFT OIL SEAL


    1. A01SDY4E03

      Apply MP grease to the lip of a new front crankshaft oil seal.

      Note


      • Keep the lip free of foreign matter.

      • Do not allow MP grease to contact the dust seal.

    2. Using SST and a hammer, tap in the front crankshaft oil seal.

      SST
      09214-60010

      Note


      • The acceptable depth from the top of the timing belt case sub-assembly edge is 0.5 mm (0.0197 in.)

      • Keep the lip free from foreign matter.

      • Do not tap the front crankshaft oil seal at an angle.

      • Make sure that the front crankshaft oil seal is properly installed.

  2. INSTALL CRANKSHAFT TIMING PULLEY


    1. A01SDK0C01
      *a Inside

      Align the keyway of the crankshaft timing pulley with the crankshaft timing pulley set key located on the crankshaft, and then slide the crankshaft timing pulley into place to install it.

    2. Using SST and a hammer, tap in the crankshaft timing pulley with the flange side facing inward.

      SST
      09223-46011

  3. INSTALL TIMING BELT

    Click here