REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR ENGINE OIL SEAL


    1. Apply MP grease to the lip of a new rear engine oil seal.

      Note


      • Keep the lip free of foreign matter.

      • Do not allow MP grease to contact the dust seal.

    2. B0028G5N01

      Using SST and a hammer, tap in the rear engine oil seal to the rear engine oil seal retainer edge.

      SST
      09518-36030
      09950-70010   ( 09951-07200 )

      Note


      • The acceptable depth from the top of the rear engine oil seal retainer is 0 to 0.8 mm (0 to 0.0315 in.)

      • Keep the lip free from foreign matter.

      • Do not tap the rear engine oil seal at an angle.

      • Make sure that the engine rear oil seal is properly installed.

  2. INSTALL REAR END PLATE

    Click here

  3. INSTALL FLYWHEEL SUB-ASSEMBLY

    Click here

  4. INSTALL CLUTCH DISC ASSEMBLY


  5. INSTALL CLUTCH COVER ASSEMBLY


  6. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY


  7. INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY