Click here

REAR CRANKSHAFT OIL SEAL INSTALLATION

Click here
Click here Click here

PROCEDURE


  1. Click here

    INSTALL REAR ENGINE OIL SEAL


    1. Apply MP grease to the lip of a new rear engine oil seal.

      Note:

      • Keep the lip free of foreign matter.

      • Do not allow MP grease to contact the dust seal.

    2. B0068RGC01
      *1 Rear Oil Seal Retainer
      *2 Rear Engine Oil Seal
      *a 0 to 1.0 mm (0 to 0.0394 in.)

      Using SST and a hammer, tap in the rear engine oil seal to the rear engine oil seal retainer edge.

      09351-40010 09351-04010 09351-04020
      Note:

      • The acceptable depth from the top of the rear engine oil seal retainer is 0 to 1.0 mm (0 to 0.0394 in.)

      • Keep the lip free from foreign matter.

      • Do not tap the rear engine oil seal at an angle.

      • Make sure that the rear engine oil seal is properly installed.

  2. Click here

    INSTALL REAR END PLATE

    Click here

  3. Click here

    INSTALL FLYWHEEL SUB-ASSEMBLY

    Click here

  4. Click here

    INSTALL CLUTCH DISC ASSEMBLY (for Manual Transmission)


  5. Click here

    INSTALL CLUTCH COVER ASSEMBLY (for Manual Transmission)


  6. Click here

    INSPECT AND ADJUST CLUTCH COVER ASSEMBLY (for Manual Transmission)


  7. Click here

    INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

    Click here

  8. Click here

    INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission)