Click here

DRIVE BELT INSTALLATION

Click here
Click here

PROCEDURE


  1. Click here

    INSTALL FAN AND GENERATOR V BELT


    1. Set the fan and generator V belt onto each part.

      Tip:

      When installing the fan and generator V belt, attach the fan and generator V belt to the No. 1 idler pulley sub-assembly last.

    2. While turning the V-ribbed belt tensioner assembly clockwise, remove the pin.

    3. Check that the fan and generator V belt fits properly in the ribbed grooves.

      Note:

      Make sure that the fan and generator V belt is set properly on each pulley.

  2. Click here

    INSTALL VISCOUS HEATER V BELT (w/ Viscous Heater)


    1. Install the viscous heater V belt.

    2. A01WA0O

      Turn the bolt and adjust the tension of the viscous heater V belt.

    3. A01WB13

      Tighten the 2 bolts and nut.

      39 N*m 398 kgf*cm 29 ft.*lbf

    4. Check the tension of the viscous heater V belt.

  3. Click here

    INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for 4WD and Pre-Runner)

    Click here