REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR ENGINE OIL SEAL


    1. Apply MP grease to the lip of a new rear engine oil seal.

      Note


      • Keep the lip free of foreign matter.

      • Do not allow MP grease to contact the dust seal.

    2. B0028G5N01

      Using SST and a hammer, tap in the rear engine oil seal to the rear engine oil seal retainer edge.

      SST
      09518-36030
      09950-70010   ( 09951-07200 )

      Note


      • The acceptable depth from the top of the rear engine oil seal retainer is 0 to 0.8 mm (0 to 0.0315 in.)

      • Keep the lip free from foreign matter.

      • Do not tap the rear engine oil seal at an angle.

      • Make sure that the engine rear oil seal is properly installed.

  2. INSTALL REAR END PLATE

    Click here

  3. INSTALL FLYWHEEL SUB-ASSEMBLY

    Click here

  4. INSTALL CLUTCH DISC ASSEMBLY (for Manual Transmission)

    Click here

  5. INSTALL CLUTCH COVER ASSEMBLY (for Manual Transmission)

    Click here

  6. INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission)

    Click here

  7. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

    Click here