CYLINDER HEAD DISASSEMBLY

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the cylinder head sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link

  • Replacement of cylinder head sub-assembly

  • Replacement of cylinder head LH

 Inspection after repair Poor idle, engine start, etc.

Click here

PROCEDURE


  1. REMOVE VALVE LIFTER


    1. Remove the valve lifter.

      Tech Tips

      Arrange the removed parts so that they can be reinstalled in their original locations.

  2. REMOVE VALVE

    Tech Tips

    Arrange the removed parts so that they can be reinstalled in their original locations.


    1. A01L9W1N01

      Using SST, compress the inner compression spring and remove the valve spring retainer lock.

      SST
      09202-70020   ( 09202-00010 )

    2. Remove the valve, inner compression spring and valve spring retainer.

  3. REMOVE VALVE SPRING SEAT


    1. A01L8MT

      Using compressed air and a magnet hand, remove the valve spring seat by blowing air.