CYLINDER HEAD GASKET COMPONENTS
ILLUSTRATION
| *1 | CHAIN SUB-ASSEMBLY | *2 | CHAIN TENSIONER SLIPPER |
| *3 | NO. 1 IDLE GEAR SHAFT | *4 | NO. 2 IDLE GEAR SHAFT |
| *5 | IDLE SPROCKET ASSEMBLY | *6 | NO. 1 CHAIN TENSIONER ASSEMBLY |
| *7 | NO. 2 CHAIN SUB-ASSEMBLY | *8 | NO. 2 CHAIN TENSIONER ASSEMBLY |
| *9 | NO. 2 CHAIN VIBRATION DAMPER | *10 | CAMSHAFT TIMING GEAR ASSEMBLY |
| *11 | CAMSHAFT TIMING SPROCKET | *12 | O-RING |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | CAMSHAFT TIMING GEAR ASSEMBLY | *2 | NO. 1 CHAIN VIBRATION DAMPER |
| *3 | NO. 3 CHAIN TENSIONER ASSEMBLY | *4 | NO. 2 CHAIN SUB-ASSEMBLY |
| *5 | CAMSHAFT TIMING SPROCKET | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | CAMSHAFT | *2 | CYLINDER HEAD GASKET |
| *3 | CYLINDER HEAD SUB-ASSEMBLY | *4 | NO. 1 CAMSHAFT BEARING |
| *5 | NO. 2 CAMSHAFT BEARING | *6 | REAR WATER BY-PASS JOINT |
| *7 | NO. 2 CAMSHAFT | *8 | NO. 1 CAMSHAFT BEARING CAP |
| *9 | NO. 2 CAMSHAFT BEARING CAP | *10 | NO. 3 CAMSHAFT BEARING CAP |
| *11 | O-RING | *12 | CYLINDER HEAD SET BOLT |
| *13 | GASKET | *14 | PLATE WASHER |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| *T1 | 1st: 36 (367, 27) 2nd: Turn 180° |
- | - |
ILLUSTRATION
| *1 | CYLINDER HEAD LH | *2 | NO. 2 CYLINDER HEAD GASKET |
| *3 | NO. 3 CAMSHAFT SUB-ASSEMBLY | *4 | NO. 4 CAMSHAFT SUB-ASSEMBLY |
| *5 | NO. 4 CAMSHAFT BEARING CAP | *6 | NO. 3 CAMSHAFT BEARING CAP |
| *7 | NO. 2 CAMSHAFT BEARING CAP | *8 | PLATE WASHER |
| *9 | CYLINDER HEAD SET BOLT | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| *T1 | 1st: 36 (367, 27) 2nd: Turn 180° |
- | - |