Click here

HEATED OXYGEN SENSOR REMOVAL

Click here
Click here Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the heated oxygen sensor removal/installation are shown below.

Table 1. Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Gas leaks from exhaust system Inspection After Repair Poor idle, engine start, etc.

Click here
CAUTION:
B0068W8

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

Click here

PROCEDURE


  1. Click here

    REMOVE HEATED OXYGEN SENSOR

    CAUTION:

    To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


    1. A01SC8BC01
      *A for 2WD
      *B for 4WD

      Disconnect the heated oxygen sensor connector.

    2. for 2WD.

      Detach the sensor wire from the 4 clamps.

    3. for 4WD.

      Detach the sensor wire from the clamp.

    4. A01SAW5C01
      *A for 2WD
      *B for 4WD

      Using SST, remove the heated oxygen sensor.

      09224-00011