AIR FUEL RATIO SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link

  • Replacement of air fuel ratio sensor

  • Gas leaks from exhaust system

 Inspection After Repair Poor idle, engine start, etc.

Click here

CAUTION:


  • B0068AA

    To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.

  • B0068W8

    To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

PROCEDURE


  1. REMOVE FRONT FENDER SEAL RH

    Click here

  2. REMOVE AIR FUEL RATIO SENSOR

    CAUTION:

    To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


    1. A01SEUJ

      Disconnect the air fuel ratio sensor connector.

    2. Detach the 3 wire harness clamps.

    3. A01SBYHN01

      Using SST, remove the air fuel ratio sensor.

      SST
      09224-00011