POWER STEERING OIL PRESSURE SWITCH INSTALLATION

PROCEDURE

1. INSTALL POWER STEERING OIL PRESSURE SWITCH

   
   

   1. Apply a light coat of engine oil to the O-ring of the power steering oil pressure switch.

   2. Using a 19 mm deep socket wrench, install the power steering oil pressure switch.

      Torque:

      20.6 N*m  { 210 kgf*cm, 15 ft.*lbf }

      Note

      
      

      • Do not allow foreign matter to contact the oil seal face of the power steering oil pressure switch (the surface that contacts the pressure feed tube).

      • When reusing the power steering oil pressure switch, inspect the O-ring.

      • Make sure that the O-ring is not cracked or jammed when installing the power steering oil pressure switch.

   3. Connect the power steering oil pressure switch connector.

2. ADD POWER STEERING FLUID

3. BLEED AIR FROM POWER STEERING SYSTEM

   Click here

4. INSPECT FOR POWER STEERING FLUID LEAK