THROTTLE BODY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the throttle body with motor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link

  • Replacement of throttle body with motor assembly

  • Cleaning the deposits from the throttle body with motor assembly

Inspection After Repair Poor idle, engine start, etc.

Click here

PROCEDURE


  1. DRAIN ENGINE COOLANT

    Click here

  2. REMOVE INTAKE AIR CONNECTOR


    1. A01LF5E

      w/ Secondary Air Injection System:


      1. Disconnect the connector and detach the wire harness clamp.

      2. Disconnect the vacuum hose from the air pressure sensor and detach the clamp.

    2. A01LBJM

      Slide the clip and disconnect the No. 2 PCV hose from the cylinder head cover sub-assembly.

    3. Disconnect the vacuum hose.

    4. Slide the clip and disconnect the No. 1 air hose from the intake air connector.

    5. A01L9ZW

      Loosen the 2 hose clamps and remove the 2 bolts and intake air connector.

  3. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    1. Disconnect the throttle body with motor connector.

    2. Slide the 2 hose clips and disconnect the No. 1 water by-pass hose and No. 2 water by-pass hose from the throttle body with motor assembly.

    3. A01LEEL

      Remove the 4 bolts and the throttle body with motor assembly.

    4. Remove the gasket from the intake manifold.