CRANKSHAFT POSITION SENSOR INSTALLATION

PROCEDURE

1. Click here

   INSTALL CRANKSHAFT POSITION SENSOR

   
   
   1. 

      *1

      O-Ring

      Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

   2. Install the crankshaft position sensor with the bolt.

      9.0 N*m

      92 kgf*cm

      80 in.*lbf

      Note:
      

      • When reusing the crankshaft position sensor, inspect the O-ring.

      • Make sure that the O-ring is not cracked or jammed when installing the crankshaft position sensor.

   3. Connect the crankshaft position sensor connector to the connector bracket.

   4. Attach the harness clamp.

   5. Connect the crankshaft position sensor connector.

2. Click here

   INSTALL NO. 1 COMPRESSOR MOUNTING BRACKET

   Click here

3. Click here

   CONNECT COOLER COMPRESSOR ASSEMBLY

   
   
   1. 

      Using an E8 "TORX" socket wrench, temporarily connect the cooler compressor assembly with the 2 stud bolts.

   2. Tighten the 2 stud bolts.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

   3. 

      Tighten the 2 nuts and 2 bolts in the order shown in the illustration to connect the cooler compressor assembly.

      24.5 N*m

      250 kgf*cm

      18 ft.*lbf

   4. Connect the cooler compressor connector.

   5. Connect the suction hose sub-assembly with the bolt.

      5.4 N*m

      55 kgf*cm

      48 in.*lbf

4. Click here

   INSTALL FRONT UPPER FENDER APRON SEAL LH

   Click here

5. Click here

   INSTALL FAN AND GENERATOR V BELT

   Click here

6. Click here

   INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

   Click here