KNOCK SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the knock sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of knock sensor Inspection After Repair Poor idle, engine start, etc.

Click here

PROCEDURE


  1. REMOVE INTAKE MANIFOLD

    Click here

  2. REMOVE KNOCK SENSOR


    1. Disconnect the knock sensor connector.

    2. A01W98D

      Remove the bolt and knock sensor.