Click here

FUEL SYSTEM ON-VEHICLE INSPECTION

Click here
Click here

PROCEDURE


  1. Click here

    INSPECT FOR FUEL LEAK


    1. Check that there are no fuel leaks anywhere in the fuel system after performing maintenance.

      Tip:

      When checking for fuel leaks, make sure that there is pressure in the fuel line.

  2. Click here

    CHECK FUEL SYSTEM WARNING LIGHT AND DRAIN WATER


    1. w/ Multi-information Display:

      Check the fuel system warning is displayed on the multi-information display, replace the fuel filter element assembly (Click here) or drain the water in the fuel filter assembly.

    2. B0028K9C02
      *a Fuel System Warning Light *b Fuel Filter Condition
      *c Necessary Procedure *d On
      *e Off *f Illuminate
      *g Blinking *h Clogged
      *i Water Level Warning *j Replace the Fuel Filter Element Assembly
      *k Drain the Water - -

      w/o Multi-information Display:

      Check the fuel system warning light in the combination meter assembly and either replace the fuel filter element assembly (Click here) or drain the water in the fuel filter assembly based on the instructions shown in the illustration.

    3. Drain water.


      1. A01SDSPC01
        *1 Lead Wire

        Disconnect the clamp and slide the lead wire as shown in the illustration to remove it.

      2. A01SE8F

        Disconnect the level warning switch connector.

      3. A01SBWE

        Slide the fuel filter assembly and lift it up.

      4. A01SBR6C01
        *1 Drain Cock
        *2 Hose

        Connect a hose to the drain cock. Place the other end of the hose into a container under the drain cock.

      5. Loosen the drain cock to drain water.

      6. Operate the hand pump until fuel begins to run out.

      7. Tighten the drain cock by hand.

        Note:

        Do not use any tools in this procedure.

      8. A01SEID

        Slide the fuel filter assembly to install it.

      9. Connect the level warning switch connector.

      10. A01SCYNC01
        *1 Lead Wire

        Attach the clamp and slide the lead wire as shown in the illustration to install it.