Click here

AIR FUEL RATIO SENSOR INSTALLATION

Click here
Click here Click here

PROCEDURE


  1. Click here

    INSTALL AIR FUEL RATIO SENSOR

    Tip:

    Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.

    Click here

    w/ DPF:

    Click here


    1. B0028NIC01
      *a Torque Wrench Fulcrum Length

      Using SST, install the air fuel ratio sensor.

      09224-00011
      Specified tightening torque
      44 N*m 449 kgf*cm 32 ft.*lbf
      Tip:

      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 37.7 N*m (384 kgf*cm, 28 ft.*lbf)

    2. Connect the connector and clamp.

  2. Click here

    INSPECT FOR EXHAUST GAS LEAK

    Click here

  3. Click here

    INSTALL FRONT FENDER SEAL RH


    1. for 2WD:


      1. Install the front fender seal RH with 5 new clips.

    2. for 4WD and Pre-Runner:


      1. Install the front fender seal RH with 6 new clips.