ECD SYSTEM(w/o EGR System), Diagnostic DTC:P00BB

DTC Code DTC Name
P00BB Fuel Injector Insufficient Flow - Forced Limited Power

DESCRIPTION

In order to detect blockages in the positive pressure filter, the ECM determines if the fuel pressure of the common rail has deviated from the target value every 5000 km. If the average value of the judgment values recorded every 5000 km exceeds the threshold, a blockage is determined to be occurring in the positive pressure filter and a DTC is stored.

Also, at the same time, the go to service warning light illuminates and engine output is limited. The go to service warning light turns off after clearing the DTC.

B002632C01
*1 Fuel Supply Pump Assembly *2 Pressurized fuel filter
*3 Fuel Filter Element Assembly *4 Fuel Tank
*5 to Common Rail Assembly *6 from Fuel Injector Assembly
B0024II High Pressure Fuel B0068O0 Feed fuel
B0068CQ Suction Fuel B00285T Return Fuel
DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P00BB Fuel Injector Insufficient Flow - Forced Limited Power

The average judgment value of the fuel pressure deviation state every 5000 km exceeds the threshold.

(1trip detection logic)

  • Fuel filter cap with element

  • Fuel filter element assembly

-*

*: Go to service warning light in combination meter

 DTCs tored
Related Data List
DTC No. Data List
P00BB

  • Common Rail Pressure

  • Target Common Rail Pressure

CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P00BB Idling for 1 seconds or more

CAUTION / NOTICE / HINT

Tech Tips

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

PROCEDURE


  1. CHECK DTC OUTPUT


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS ON.

    3. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


      Powertrain > Engine and ECT > Trouble Codes

    4. Read the DTCs.

      Result
      P00BB is output.

      Tech Tips

      When P00BB is output, the fuel filter cap with element needs to be replaced. In order to inspect the fuel filter element assembly for blockages, do not perform replacement at this stage.

      Result
      Proceed to
      NEXT

    NEXT

  2. INSPECT FUEL FILTER ELEMENT ASSEMBLY


    1. Disconnect the clogging switch connector from the fuel filter element assembly.

    2. Start the engine and warm it up.

    3. Connect a circuit tester to the clogging switch.

    4. Check that the clogging switch does not turn OFF (10 kΩ or higher) when revving the engine up from idling.

      Tech Tips

      If the clogging switch turns OFF, it can be determined that the fuel filter element assembly is becoming clogged.

      OK
      The clogging switch does not change from ON (below 1Ω) when revving the engine up from idling.
      Result
      Proceed to
      OK
      NG

    NG

    REPLACE FUEL FILTER ELEMENT ASSEMBLY Click here

    OK

  3. REPLACE FUEL FILTER CAP WITH ELEMENT


    1. Replace the fuel filter cap element.

      Result
      Proceed to
      NEXT

    NEXT

  4. BLEED AIR FROM FUEL SYSTEM


    1. Bleed the air from the fuel system.

      Result
      Proceed to
      NEXT

    NEXT

  5. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Clear the DTCs.


      Powertrain > Engine and ECT > Clear DTCs

      Tech Tips

      Clearing the DTCs turns off the go to service warning light.

      Result
      Proceed to
      NEXT

    NEXT

    END

  6. REPLACE FUEL FILTER ELEMENT ASSEMBLY


    1. Clean the fuel filter element assembly.

      Result
      Proceed to
      NEXT

    NEXT

    GO TO STEP 3 Click here