ACCELERATOR PEDAL ON-VEHICLE INSPECTION

Click here

PROCEDURE

1. Click here

   INSPECT ACCELERATOR PEDAL SENSOR

   
   

   1. Connect the GTS to the DLC3.

   2. Turn the ignition switch to ON.

   3. Turn the GTS on.

   4. Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sens. No.1 Volt % and Accel Sens. No.2 Volt %.

      
      
      1. Powertrain > Engine > Data List

         Tester Display
         Accel Sens. No.1 Volt %
         Accel Sens. No.2 Volt %

      2. 
         
         1. 
            
      3. 
         
         10. 
             
         11. 
             

   5. Operate the accelerator pedal rod and check that the "Accel Sens. No.1 Volt %" and "Accel Sens. No.2 Volt %" values are within the specification.

      If the result is not as specified, refer to DTC P2120.

      Click here