Click here

ECM REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures(adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during ECM removal/installation are shown below.

Table 1. Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Work Necessary Procedures Effects/Inoperative when not Performed Link
ECM

  • Learning values save

  • Learning values write

  • Vehicle Identification Number (VIN) registration

 Engine starting

Click here
Code registration (Immobilizer system) Engine start function See the Service Bulletin for the registration method.
Click here

PROCEDURE


  1. Click here

    REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  2. Click here

    REMOVE ECM


    1. Disconnect the 4 ECM connectors and clamp.

    2. B0026Q6C01
      *A for LHD
      *B for RHD

      Remove the bolt, 2 nuts and ECM, No. 1 and No. 2 ECM brackets.

  3. Click here

    REMOVE NO. 1 ECM BRACKET


    1. B0025OVC01
      *A for LHD
      *B for RHD

      Remove the 2 screws and No. 1 ECM bracket.

  4. Click here

    REMOVE NO. 2 ECM BRACKET


    1. B0025L7C01
      *A for LHD
      *B for RHD

      Remove the 2 screws and No. 2 ECM bracket.